by James Perloff, James Perloff:
Since publishing “9/11 Simplified,” I’ve received emails from six pilots, none of whom accept the official 9/11 story. Two were scheduled to fly in Boeings on the morning of 9/11.
Another is a UK-born pilot with about 20 years of flight experience. He is still actively flying as a captain on Airbus A300s, and spent many years training airline pilots. He has provided me with so many technological insights into aviation and 9/11 that I felt I should publish excerpts from our exchanges. For enhancement, I have added a few graphics and embedded some of the video clips he referred me to. For clarity, my comments are in bold and his in normal font. Of course, what we originally said has been rearranged into a more orderly sequence.
To keep his identity confidential, I’ll call him “Pilot A.” Some of his remarks bear on 9/11 in general, and some are specific to my article “9/11 Simplified,” so it will be helpful to readers if they are familiar with that post, which I may eventually republish in a revised edition.
Pilot A greeted me saying:
Great shows about “9-11 simplified” and I agree with most of your analysis so far, so please keep up the good work.
He knew from personal experience that the U.S. government’s theory of how the Twin Towers collapsed is bogus.
I know, like many others do, that heavy fuel like diesel and jet fuel cannot melt steel. Even Oxy-Acetylene or Oxy-Propane cutting torches require large amounts of high pressure oxygen injected into the fuel stream to melt steel, and it takes some time to get thick steel up to a softening/melting state. I went to tech college in the 90s to qualify as a welder and gas cutting was one of the disciplines. I’ve spend countless hours cutting and fabricating steel. I had an experience with an old 600 gallon diesel tank which I was cutting the top off to convert into a storage box. In the bottom below the drain plug level was some remaining fuel and sludge, but as I got about 3/4 of the way through cutting the lid off, the molten metal ignited the fuel in the bottom. The dirty fire that poured out the top burned for about 30 minutes, but the wafer thin (3 mm) steel didn’t even glow.
Pilot A agreed with my article’s 10-point proposal that small nuclear weapons had destroyed the Towers, and also agreed with the thesis that pre-planted thermite had indeed been used at the level of the “airplane strikes.” Most of us in the 9/11 community have seen the famous footage of molten steel dripping from a corner of the South Tower:
However, Pilot A had an insight about this I had not thought of:
Now I do think they used thermite as it was probably part of the structural weakening component, but could also have been part of the show to try and prove that “Look, jet fuel does melt steel!”
In my article I had discussed various evidences against jetliners striking the Towers, such as the uncontrollable speeds, and the impossible physics of an aluminum tail and wings and flying through 14-inch steel columns without breaking off. I had concluded that cloaked missiles, or possibly drones, were better explanations. I ask Pilot A what the likelihood was of commercial jetliners hitting the Towers:
Well, I have a couple of extra variables to your main idea for you to play with so here goes:
If you’re going to plan a dastardly event like a “New Pearl Harbour” to achieve all the things like more war, military spending, contracts for the corporate criminals, police state etc., then you want as much shock and horror as possible which includes, noise, fire, smoke and destruction on steroids. The planners would need this area of the operation a guaranteed certainty, no chance of foul-ups anywhere, total control, no variables, flawless. You wouldn’t use actual commercial jetliners piloted by humans to achieve this, too much to go wrong. E.g., the pilots could “chicken-out,” miss the towers, partially hit the towers, passengers could over-run the cockpit, the jet fuel might not ignite so no fire and explosion (more on that later), the damage to the building might be too little, pathetically small even, rogue military pilot ignoring orders to buzz off somewhere else might actually shoot the planes down . . . and on and on it goes.
What’s better than planes flying into buildings? The illusion of planes flying into buildings. Especially if it’s a high explosive/incendiary guided missile with some sort of holographic projection device strapped to its back. Better still let’s have 3 or 4 of them for damage consistency to really make a statement. These can be controlled by a central source, have a known and guaranteed outcome because the military has umpteen thousand examples of the destructive power of missiles, and they can be sent to a specific target with pin point accuracy and timing – perfect.
Passenger planes are very difficult to fly accurately with only external visual reference. With no electronic guidance or without heads-up display technology it’s too risky to try and fly into a specific point by line of sight. Not all pilots have the same level of skill or experience, and this sort of thing you only get to practice for real once!! Simulators have their limits as well for this sort of practice. I can almost see the pilots that have probably tried this in the simulators and predict the outcomes. An educated guess would be overcompensation to try and maintain an accurate flight path at high speed. The air that planes fly through isn’t always constant. There are pools and eddies like a river with rocks, changing currents and speeds. All these require constant adjustment which is easily achieved on approach at 140 knots, with all the control surfaces moving at their full potential and the aircraft slow enough to keep inertia to a minimum. But completely impossible for a novice pilot with only some light aircraft flight experience.
I don’t know how you could do a last-minute modification to a flight path to achieve this accuracy at the speed they were supposedly traveling. Once you get above 200 knots all the moving surfaces (Ailerons, Elevators, Rudder) are in high speed mode and become either artificially loaded or movement restricted to prevent excessive loading and structural damage. If you were slightly off course, you couldn’t make any large corrections to the trajectory at the last minute; everything is done gently. Plus eye-balling your way around a city you’ve never flown over before (if you believe the Muslim hijacker theory) is near impossible, even for a local city dweller! The city layout is different when looking down on it and the view from the flight deck is very limited, unlike a Cessna which has great views. And traveling at hundreds of knots makes this all the more idiotic to achieve.
So if the planes missed the towers, or partially struck the towers, or the jet fuel failed to ignite, then the Hollywood-style fireball scene is a flop. Jet fuel, which is basically paraffin, needs certain requirements to burn. Unlike the petrol gas (95/98) stuff that you put in your Chevy, Avtur (Aviation Turbine Fuel) won’t ignite if you pour some on the ground and throw a match or lighter into it. I know, I’ve tried it. It usually requires heat (compression chamber) and/or pressure (injector nozzle) to combust. The likelihood, though, is that it would probably ignite because the engines were hot, but not guaranteed especially if the engines sheared off on the outside of the building. Yet more variables.
Read More @ JamesPerloff.com